Based on Fiat's small sedan 131 that appeared in 1974, Abarth has tuned each part. The 131 Abarth Rally has been participating in the World Rally Championship since 1976 and brought Fiat three championships. This is an electric RC car assembly kit that reproduces the specifications of the Fiat genuine oil "OLIO FIAT" that was active in 1976 and 1977. The stylish 2-door sedan body with straight lines and over fenders and spoiler make the fearless figure realistically reproduced using polycarbonate. The main body is painted dark blue and camel yellow, and the window part is painted smoked. Furthermore, in addition to cutting the wheel arches, we also drilled holes for the body catches. In addition, the four round headlights, spotlights, roof spoiler, etc. are made up of separate parts. In addition to the painted body, this is a great model with a high scale finish.

[MF-01X chassis, a compact shaft 4WD that expands the driving scene]

The chassis uses the MF-01X, a compact 4WD that allows you to enjoy driving on any road surface, from on-road to dirt. The highly strong left-right split monocoque frame has been integrated with the gearbox for ease of assembly. A motor is mounted on the rear end, and power is transmitted to the rear wheels using gears and to the front wheels using a propeller shaft. A differential gear is installed in the front and rear sealed gear cases to achieve smooth cornering. Furthermore, the battery for driving is set almost in the center of the vehicle body for a good weight balance. The suspension consists of 4 independent double wishbone wheels equipped with friction dampers. The upright hub carrier is for the M-05Ra chassis, which is compatible with off-road driving. The classically designed dish wheels are equipped with Rally Block tires.

[Basic specifications] 

●Overall length 400mm, overall width 180mm, overall height 132mm

●Wheelbase 239mm (L size)

●Tire width/diameter = front and rear 60/26mm

●Tread = front and rear 138mm

●Frame = monocoque type

●Drive system = shaft drive 4WD

●Differential gear = 3 bevel type

●Steering = 2-split tie rod type

●Suspension = 4 independent double wishbone wheels

●Damper = friction both front and rear

●Gear ratio = 9.5:1

●540 type motor included

●Speed ​​controller = ESC specification (sold separately)

[ Items to be purchased separately】 

● Fine spec 2.4G electric RC drive set 

●4 AA batteries for transmitter