The strong wedge-shaped line composed of the body and large rear wing is just like a Boomerang. A reprint of the Boomerang, which was introduced in 1986 as an introductory 4WD racing buggy and quickly gained popularity. The basic configuration remains the same, but each part has been fine-tuned, including equipping the gearbox with ball bearings and thrust ball bearings, and installing a new chassis cover that increases the reliability of off-road driving

The chassis, which uses shaft drive 4WD, is basically inherited from the drivetrain of the famous Hot Shot car. High maintainability unique to the 3-part structure consisting of front and rear gearboxes and bathtub frame. is attractive. The suspension is a 4-wheel double wishbone. The front is equipped with a monoshock oil damper and stabilizer inherited from Hotshot, and the rear is equipped with two long CVA oil dampers. In addition, a chassis cover has been added this time. Furthermore, you can enjoy improved performance by incorporating the DF-02 universal shaft and DF-03 aluminum damper set. [

Basic specifications] 

●Overall length 385mm, overall width 234mm, overall height 153mm 

● Vehicle weight approximately 1160g (not including RC mechanism and battery)

●Tread=F196mm R194mm

●Tire width/diameter=F30/88mm R38/88mm

●Frame=ABS resin bathtub

●Drive system=shaft drive 4WD

●Differential gear=3 bevels front and rear

● Steering = 3-split tie rod type

●Suspension = 4-wheel double wishbone

●Gear ratio = 8.7:1 10.04:1

●Motor = RS540 type

●Speed ​​controller = ESC specification (sold separately)